Chemistry Unit 3: Atomic Structure
This Chemistry unit, Atomic Structure, has 5 lessons that cover TEKS C.6A, C.6B, C.6C, C.6D, C.6E. Each lesson below gives the goal, key vocabulary, a worked example and practice questions with answers you can check.
Practice this unit with interactive questions
TEKS covered in this unit
- C.6A Construct models showing the development of modern atomic theory from Dalton through Heisenberg
- C.6B Describe the structure of atoms and ions, including subatomic particles’ masses, charges and locations
- C.6C Investigate the relationship among energy, frequency and wavelength of light and relate it to energy quantization in emission spectra
- C.6D Calculate average atomic mass from isotopic composition
- C.6E Construct models of electron configurations and Lewis dot structures for representative elements
Lesson 1: Models of the atom
TEKS C.6A
What you will learn
I can construct models showing how atomic theory developed from Dalton through Thomson, Rutherford, Bohr and Heisenberg, and explain the evidence behind each change.
I can match each experiment to the model change it caused.
Key vocabulary
- nucleus
- The tiny, dense, positively charged center of an atom that contains protons and neutrons.
Examples: Found by Rutherford’s gold foil experiment; Holds almost all the mass - electron cloud model
- The modern model in which electrons are found in regions of probability called orbitals, not on fixed paths.
Examples: The s orbital as a sphere; The p orbital as a dumbbell - uncertainty principle
- It is impossible to know both the exact position and the exact momentum of an electron at the same time.
Examples: Why electrons are modeled as clouds; Why exact paths cannot be drawn
Worked example
In Rutherford’s experiment, alpha particles were fired at thin gold foil. Most passed straight through, a few were deflected at large angles and about 1 in 8,000 bounced almost straight back. What did he conclude?
- Most particles passed straight through.
This shows an atom is mostly empty space, which contradicted the plum pudding model of a solid sphere. - A few were deflected strongly.
Only a concentrated positive charge could repel the positive alpha particles so strongly. - About 1 in 8,000 bounced back, so the positive charge and mass are in a tiny region.
The small fraction shows how small the nucleus is compared with the whole atom. - Conclusion: atoms have a tiny, dense, positive nucleus surrounded by empty space with electrons.
This replaced Thomson’s model, because new evidence did not fit the old one.
Strategy: Experiment, result, conclusion
- Name the experiment.
- Describe the unexpected result.
- Say what the old model could not explain.
- State the new idea.
Check your understanding
What did the gold foil experiment show?
- Neutrons are charged
- Atoms are solid
- Electrons in a pudding
- A tiny, dense, positive nucleus
Show the answer
Answer: D. A tiny, dense, positive nucleus
Atoms are mostly empty space with a nucleus.
Which scientist discovered the electron?
- Bohr
- Rutherford
- Dalton
- Thomson
Show the answer
Answer: D. Thomson
Thomson found the electron.
What did line spectra support?
- Electrons have no energy
- Atoms are solid
- Electrons have fixed energy levels
- The nucleus is negative
Show the answer
Answer: C. Electrons have fixed energy levels
Only certain energies are allowed.
Lesson 2: Protons, neutrons, electrons and ions
TEKS C.6B
What you will learn
I can describe the structure of atoms and ions, including the masses, charges and locations of protons, neutrons and electrons.
I can find the numbers of protons, neutrons and electrons from an atom or ion symbol.
Key vocabulary
- mass number
- The total number of protons and neutrons in an atom’s nucleus.
Examples: Carbon-12 has mass number 12; Chlorine-35 - ion
- An atom that has gained or lost electrons and so has an overall electric charge.
Examples: Na⁺ (lost an electron); O²⁻ (gained two) - isotope
- Atoms of the same element with different numbers of neutrons.
Examples: Carbon-12 and carbon-14; Hydrogen-1 and hydrogen-2
Worked example
Find the number of protons, neutrons and electrons in a neutral atom of aluminum-27 (atomic number 13).
- Protons = atomic number = 13.
The number of protons defines the element, so every aluminum atom has 13. - Neutrons = mass number − protons = 27 − 13 = 14.
The mass number counts protons and neutrons, so subtracting the protons leaves the neutrons. - A neutral atom has equal protons and electrons, so electrons = 13.
Equal numbers of + and − charges cancel, making the atom neutral. - Check the mass: 13 protons + 14 neutrons = 27 particles in the nucleus.
Adding them back to the mass number is a quick way to confirm the arithmetic.
Strategy: Protons first, then neutrons, then electrons
- Atomic number = protons.
- Mass number − protons = neutrons.
- Electrons = protons − charge.
- Check the totals.
Check your understanding
What does the atomic number tell you?
- The charge
- The total mass
- The number of neutrons
- The number of protons
Show the answer
Answer: D. The number of protons
It equals the proton count.
How many neutrons are in carbon-14?
- 20
- 14
- 6
- 8
Show the answer
Answer: D. 8
14 − 6 = 8.
An atom that loses an electron becomes…
- A negative ion
- A positive ion
- An isotope
- A new element
Show the answer
Answer: B. A positive ion
It has a 1+ charge.
Lesson 3: Light, energy levels and emission spectra
TEKS C.6C
What you will learn
I can investigate how the energy, frequency and wavelength of light are related and connect that to energy quantization and emission spectra.
I can use c = λν and E = hν to compare colors of light.
Key vocabulary
- wavelength (λ)
- The distance between two matching points on neighboring waves, such as crest to crest.
Examples: Red light about 700 nm; Violet light about 400 nm - frequency (ν)
- The number of wave cycles that pass a point each second, measured in hertz (Hz).
Examples: 5.0 × 10¹⁴ Hz; FM radio at 100 MHz - photon
- A packet of light energy. The energy of a photon is proportional to its frequency.
Examples: One photon of blue light; Light emitted when an electron drops levels
Worked example
Green light has a wavelength of 5.20 × 10⁻⁷ m. Calculate its frequency. (c = 3.00 × 10⁸ m/s)
- Use c = λν, so ν = c ÷ λ.
Rearranging the equation isolates the frequency, which is what the question asks for. - ν = (3.00 × 10⁸ m/s) ÷ (5.20 × 10⁻⁷ m).
Substituting with units keeps track of what each number means. - ν = 5.77 × 10¹⁴ s⁻¹ (Hz).
Meters cancel and leave 1/s, the unit of frequency, which confirms the setup. - Check: visible light frequencies are around 10¹⁴ Hz.
A result in the expected range gives confidence that the exponent is right.
Strategy: Wave speed, photon energy, level gaps
- Use c = λν for wavelength and frequency.
- Use E = hν for energy.
- Compare colors.
- Link spectra to energy levels.
Check your understanding
If wavelength increases, frequency…
- Doubles
- Stays the same
- Increases
- Decreases
Show the answer
Answer: D. Decreases
Speed is constant, so they are inversely related.
Which photon has the most energy?
- Orange
- Red
- Violet
- Radio wave
Show the answer
Answer: C. Violet
Higher frequency means more energy.
What produces a line spectrum?
- Electrons leaving the atom
- Electrons dropping between energy levels
- Protons moving
- Neutrons decaying
Show the answer
Answer: B. Electrons dropping between energy levels
Each drop emits one photon.
Lesson 4: Isotopes and average atomic mass
TEKS C.6D
What you will learn
I can calculate the average atomic mass of an element from the masses and abundances of its isotopes.
I can use a weighted average and explain why the atomic mass on the table is not a whole number.
Key vocabulary
- atomic mass unit (amu)
- A unit of mass defined as 1/12 the mass of a carbon-12 atom.
Examples: A proton is about 1 amu; Chlorine-35 is about 35 amu - relative abundance
- The percent of atoms of an element that are a particular isotope in nature.
Examples: 75.77% chlorine-35; 24.23% chlorine-37 - weighted average
- An average in which each value is multiplied by how common it is before adding.
Examples: Mass × abundance, then add; A grade with different weights
Worked example
Chlorine has two main isotopes: chlorine-35 (34.97 amu, 75.77%) and chlorine-37 (36.97 amu, 24.23%). Calculate the average atomic mass.
- Convert each percent to a decimal: 0.7577 and 0.2423.
Decimals show each isotope’s share of the total, which must add to 1. - Multiply each mass by its decimal: 34.97 × 0.7577 = 26.496 and 36.97 × 0.2423 = 8.958.
Each isotope contributes in proportion to how common it is, so the more common isotope counts more. - Add: 26.496 + 8.958 = 35.454, which rounds to 35.45 amu.
The sum is the weighted average, which matches the value on the periodic table. - Check: 35.45 is closer to 35 than to 37.
The answer should lie between the two masses and closer to the more abundant one, so it passes the check.
Strategy: Percent to decimal, multiply, add
- List each isotope’s mass and percent.
- Convert percents to decimals.
- Multiply and add.
- Check it lies between the masses.
Check your understanding
Average atomic mass is a…
- Median
- Sum of masses
- Simple average
- Weighted average
Show the answer
Answer: D. Weighted average
Abundance weights each isotope.
If Cl-35 is more common than Cl-37, the average is…
- Exactly 36
- Closer to 37
- Closer to 35
- Greater than 37
Show the answer
Answer: C. Closer to 35
It lies nearer the more common isotope.
Why is the atomic mass on the table not a whole number?
- It counts electrons
- It averages several isotopes
- Atoms have fractions of protons
- It is rounded wrong
Show the answer
Answer: B. It averages several isotopes
It averages natural isotopes.
Lesson 5: Electron configurations and Lewis dot structures
TEKS C.6E
What you will learn
I can construct electron configurations and Lewis dot structures for representative elements and relate them to the Periodic Table.
I can write a configuration using the Aufbau order and draw the valence electrons as dots.
Key vocabulary
- electron configuration
- The arrangement of an atom’s electrons in orbitals, written such as 1s² 2s² 2p⁶.
Examples: Neon: 1s² 2s² 2p⁶; Sodium: 1s² 2s² 2p⁶ 3s¹ - Aufbau principle
- Electrons fill the lowest-energy orbitals first: 1s, 2s, 2p, 3s, 3p, 4s, 3d.
Examples: 1s fills before 2s; 4s fills before 3d - Lewis dot structure
- A diagram that shows an atom’s valence electrons as dots around its symbol.
Examples: Chlorine with 7 dots; Carbon with 4 dots
Worked example
Write the electron configuration of phosphorus (Z = 15) and draw its Lewis dot structure.
- Fill in order: 1s² (2), 2s² (4), 2p⁶ (10), 3s² (12), 3p³ (15).
Following the Aufbau order and the capacity of each orbital (s holds 2, p holds 6) ensures the total is 15. - Check: 2 + 2 + 6 + 2 + 3 = 15 electrons.
The sum must equal the atomic number for a neutral atom. - Valence electrons are those in the highest energy level (n = 3): 3s² 3p³ = 5.
Only the outermost shell takes part in bonding, so we count only those. - Lewis structure: P with one pair and three single dots.
Dots go one per side first, then pair up, which follows Hund’s rule that electrons spread out in orbitals before pairing.
Strategy: Fill in order, check the total, count the outer shell
- Use the order 1s 2s 2p 3s 3p 4s 3d.
- Check the total equals Z.
- Count the highest-level electrons.
- Draw the dots.
Check your understanding
How many electrons can the 2p subshell hold?
- 14
- 10
- 2
- 6
Show the answer
Answer: D. 6
A p subshell holds six.
The configuration 1s² 2s² 2p⁶ 3s² 3p⁴ is…
- Silicon
- Oxygen
- Sulfur
- Argon
Show the answer
Answer: C. Sulfur
16 electrons: sulfur.
How many valence electrons does phosphorus have?
- 5
- 8
- 15
- 3
Show the answer
Answer: A. 5
Five in the third shell.